Rivera-primo PC-2000 Manuel d'utilisateur télécharger pdf

The PC-2000 CLUTCH HUB PULLER for tapered shaft Pro Clutch applications consists of 4 pieces. The bolt plate,

the bolt, and 2 adaptors. The long adaptor with the deep hole is use with for 4-speed (coil spring clutch) short

shaft applications, the short adaptor is for use with for long shaft 5 speed (diaphragm spring clutch).

PC-2000 INSTRUCTIONS

Loosen & remove the 4 shouldered nuts

as shown. Remove the clips, retainer,

diaphragm spring and pressure plate as

pictured.

Remove the clutch hub nut (left hand

threads) from the transmission main-

shaft.

Place the long adaptor with recess for

the clutch rod on the mainshaft as

shown.

Install the PC-2000 onto the transmis-

sion mainshaft as shown. Tighten

shouldered nuts snug, making sure that

the plate is flat on the 4 clutch hub studs.

Give it a sharp tap with a medium weight

steel hammer (wear safety goggles).

Turn the center bolt clockwise until it

contacts the adaptor on the mainshaft,

then another 1/4-1/2 turn.

3. Mount the puller plate on the

clutch hub studs using the 4

shouldered nuts. Make sure the

plate is seated evenly on all 4

studs. Make sure that all 4 nuts

are tight.

4. Turn the center bolt until it con-

tacts the adaptor positioned on the

mainshaft. Slowly turn the bolt

clockwise 1/4-to-1/2 turn putting

pressure on the plate. Give the bolt

a sharp tap with a medium weight

steel hammer. If needed, go anoth-

er 1/4 turn and repeat the tap.

RIVERA

Engineering Inc.

12450 Whittier Blvd, Whittier, CA 90602

(562) 907-2600 fax (562) 907-2606 www.riveraengineering.com

rear view

front view

1. Remove the 4 shouldered

nuts, retainer, diaphragm

spring, & pressure plate.

2. Remove the left hand thread

clutch hub nut.

3. Install the adaptor on the

end of the trans mainshaft.

apply anti seize to stud theads

prior to installing shoulder nuts

PC-2000 INSTRUCTIONS 1

Résumé du contenu

Page 1 - PC-2000 INSTRUCTIONS

The PC-2000 CLUTCH HUB PULLER for tapered shaft Pro Clutch applications consists of 4 pieces. The bolt plate,the bolt, and 2 adaptors. The long adapto

Commentaires sur ces manuels

Pas de commentaire

Rivera-primo PC-2000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Outils Rivera-primo PC-2000. Rivera Primo PC-2000 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Rivera-primo PC-2000