Rivera-primo Brute V Manuel d'utilisateur

For dependable, high performance, long-life service nothing beats a modern Primo®Belt Drives primary-drive belt-kit! Primo’s long-time tradition of “Q

1233A3BSTEP 1:Begin by removing all the OEM primary-drive componentsincluding the inner primary cover, AND THE FACTORY INNER-BEARING RACE ON THE TRANS

654STEP 4:Install the Motor Plate (front section PP-403-P or PP-503-P),Start the four front section bolts, but only hand tighten at thistime!Install

891011STEP 8:If you’re installing the Brute VTMon a Dyna Glide, check for clearancebetween the rear of the starter ring gear and the swing arm pivotnu

12131415STEPS 12 & 13:With both pulleys and the belt installed theclutch plates can now be installed. Install theclutch plates in exactly the same

161718DO NOT OPERATEthis or any other Rivera Primo Inc. open-primary belt-drive without the proper safety guard or belt cover in place. A well designe

REPLACEMENT PARTS LISTPP-IS-2A . . . 1/2” (.500”) OFFSET INSERT FOR 3-1/2” PULLEYPP-IS-3A . . . 1” (1.00”) OFFSET INSERTPP-IS-4A . . . 1-1’4” (1.25”)

RIVERA PRIMO Inc. 12450 Whittier Blvd, WHITTIER, CA 90602(562) 907-2600 FAX (562) 907-2606 E-mail: [email protected]